This product is temporarily unavailable for sale. For peel and adhesion testing, please contact us.
Contact us
TYPE:17 Adhesion and Peeling Resistance Tester
Use for Peeling and Tensile Strength Evaluations
The test piece clamps on both sides move at the same speed in opposite directions, and the resistance is accurately measured at one of the clamps.
An empty part is prepared between both clamps into which the unpeeled sample is inserted.
Accordingly, the T-type Peeling
Power supply: 100 V AC only. A step-down transformer is required for use outside Japan.
Measurement from Minute Amounts for a Wide Range of Contents
T-type peeling, 180 peeling, tension, and tearing testing can be measured, together with blocking testing for evaluation of surface adhesion.
Easy to Use
By bringing the instrument to the required location, it will be possible to quickly carry out measurement.
Zero balancing and calibration are also simple, so that anyone can operate the instrument.
* Separate measurement jigs may be required.
(Because both clamps move at the same speed in opposite directions, the measurement speed will be 100-1000mm/min.)
High Frequency Noise Prevention Circuit CMRR: AC/DC130dB or greater,
NMRR: AC50dB or greater
Output (Non-linear): ±5V (±0.05% FS or less)
Sensitivity Switching: 0, 100, 50, 25, 10% FS
SN Ratio: 60dB (Maximum sensitivity)
Response Frequency Characteristics: 2kHz/-3dB
Filter: 1, 10, 100Hz, Pass (Low pass filter)
(The dynamic strain amplifier is incorporated in the main unit)
Acrylic Cover 1 piece, Tools 1 set, Parts Case 1 unit, Operation Manual 1 book